How to Cut Tile With a Dremel

There are a few things you must know before you start cutting tiles with a dremel. You must first make sure that your tools are safe and secure to use. Once you’ve done that, you can proceed with the cutting.

Marble tiles

Cutting marble tiles with a dremel tool requires the proper attachment. This is necessary to make a smooth and clean cut. If not done correctly, your marble tile will shatter.

A dremel can be used to cut through all types of tiles. However, you should be cautious in using this tool and wear protective clothing and eyewear.

Before starting, you should measure the area of the tile you want to cut. The next step is to draw a line on the tile to guide the cutting. Depending on your preference, you can use a pencil, ruler, or even a straightedge.

Next, you should use a tile cutter. If you plan to cut rectangular or circular tiles, you should first score on the back side of the tile. You can also use a utility knife.

marble tiles
Photo by Olga Thelavart on Unsplash

Make sure that the cut you make is straight and deep. To prevent your tile from cracking, be careful not to put too much pressure on the cutting blade. Once you finish cutting, sandpaper can be used to finish the edge.


How to cut glass tile with a dremel is a straightforward process if you follow the instructions correctly. However, the process can be dangerous and a waste of time. Luckily, there are a few tools and techniques to help you get the job done right.

First, start by placing the glass tile on a flat surface. Hold a pair of nippers in one hand. Next, draw a line on the backside of the glass. Then, place a straight edge over the line. You can also clamp a piece of tape to the tile to keep the line from slipping.

Next, place the glass cutting bit in your Dremel. Make sure to set the power setting to at least six or eight. This is important because you can damage the coating on the backside of the glass. If you do, you may find the front side of the glass to be rough and jagged.

Lastly, you can use 80-grit sandpaper to smooth out the edges. Don’t press too hard. Otherwise, you’ll just end up chipping the glass.

Right angle attachment

The Dremel right angle attachment is a worthy contender in the tile cutting department, but it’s not the only one. Aside from the obvious, the right angle enables you to make a straight down cut, which is a nice feat for a tool that has a tendency to lean a bit. And, as far as safety goes, it has a hefty rubber clamp to boot.

It’s the proper way to make a smooth cut in a tiled floor. With the proper accessories and precautions, you’ll be able to achieve the finish that you’ve always wanted. But, before you rush out to purchase a Dremel, be sure to take a deep breath and read up on the nuances of the kit’s specs. This will ensure that you don’t inadvertently cut your tiles or your hands in the process.

Before you jump into your shiny new machine, be sure to consult the owner’s manual for tips and tricks. This will ensure that you’ll be able to make the best of the kit’s assortment of bits and bobs.

Safety precautions

If you’re working with a dremel, you should always take safety precautions. It’s important to follow the instructions on the manual and use safety gear. This can prevent a major accident or injury.

handheld tool lot
Photo by Cesar Carlevarino Aragon on Unsplash

When cutting tile, it is also important to have the correct tools. There are a variety of accessories you can buy to make your work easier.

Whether you’re cutting porcelain or ceramic tiles, you should use the right cutting tool. Choose a diamond-tipped blade. For natural stone, serrated blades are better. To ensure a straight cut, avoid forcing too much pressure on the tile cutting tool. You may also want to smooth rough edges with a rubbing stone.

Safety precautions also include wearing protective clothing and goggles. This will keep debris from getting into your eyes. Wearing a face mask is also recommended.

When cutting tile with a dremel, it’s important to be careful. The tool has sharp blades and can cause accidents if you don’t use it correctly.